50A Current Sensor using Hall Effect based linear current sensor ACS756
X050 (50 Amp) version (model: ACS756KCA-050B-PFF-T). Industry-leading noise performance through proprietary amplifier and filter design techniques. Total output error 0.8% at TA = 25°C. Monolithic Hall IC for high reliability. Ultra-low power loss: 130u Ohm internal conductor resistance.
This is the breakout board for the fully integrated Hall Effect based linear current sensor ACS756. It provides economical and precise solutions for AC or DC current sensing in industrial, automotive, commercial, and communications systems. Typical applications include motor control, load detection and management, power supplies, and over current fault protection. The BB-ACS756 comes with one set of Dean-T connector and a 3 ways right angle pin header. ** The connector is not soldered when purchased Features: X050 (50 Amp) version (model: ACS756KCA-050B-PFF-T) Industry-leading noise performance through proprietary amplifier and filter design techniques Total output error 0.8% at TA = 25°C Monolithic Hall IC for high reliability Ultra-low power loss: 130u Ohm internal conductor resistance 3 kV RMS minimum isolation voltage from pins 1-3 to pins 4-5 5.0 V single supply operation 3 ?s output rise time in response to step input current 40 mV/A output sensitivity Output voltage proportional to AC or DC currents Factory-trimmed for accuracy Extremely stable output offset voltage Nearly zero magnetic hysteresis Dimension: 1.43 x 1.435 inch
An on-screen display is a very important part of an FPV'ers equipment. Similar to the HUD in a fighter-plane, the OSD overlays various pieces of critical information onto the video image, which will be viewed by the FPV pilot.Important questions, such as 'Which way is home' or 'What is the state of my battery' are answered at a glance. Equally important information, such as 'how far away am I', 'how high am I', can help comply with local FPV rules & regulations.ImmersionRC's approach to on-screen displays is a little different than other manufacturers. Instead of a crowded display, with a bunch of rarely-needed information, just the essentials are shown.Included1 x 20cm 5pin molex/tinned power cable1 x 24cm 5pin/5pin Molex cable1 x 24cm 4pin/4pin Molex cable1 x 24cm 2pin/2pin Molex cable1 x 25cm GPS cable1 x 45mm GPS cableNOTE: The lipo plugs on the current sensor are XT-60 (2-6s).
Hal 200-S - Current SensorMarketing Information:CURRENT SENSORCurrent Measuring Range AC: -600A to 600ACurrent Measuring Range DC: -600A to 600ASupply Voltage DC Min: -15VSupply Voltage DC Max: 15VSensor Output: VoltageAccuracy %: 1%Response Time: 3?sAccuracy: ?? 1%RoHS Compliant: Yes
ACS758LCB-050B-PFF-T Hall Current Sensor Current Module
Current sensing in high voltage systems. 3.0 to 5.5 V, single supply operation. 120 kHz typical bandwidth. 3 μs output rise time in response to step input current. Output voltage proportional to AC or DC currents.